© Fernox 2024. All rights reserved
A universal cleaner designed for use in HVAC and light commercial heating and cooling systems, Cleaner F3 can be used for the pre-commission cleaning of new systems, removing flux residues, oil/grease and other installation debris. Cleaner F3 can also be used to remove sludge, scale and other circulating debris in existing contaminated systems, therefore improving efficiency and avoiding damage to system components. This high performance, fast-acting cleaner is compatible with all metals and materials commonly used in heating and cooling systems, including steel and aluminium. One 2.6G product treats up to a 528 gallon (2000 litre) system at a dose rate of 0.5%.
For optimum results, the entire system should be completely drainable. Cleaner F3 2.6G should be dosed at a concentration of 0.5%. The product can be introduced into the system via a suitable point such as a dosing pot. For pre-commission cleaning, circulate Cleaner F3 2.6G for at least one hour at normal operating temperature. To remove sludge from existing systems, circulate under normal operating conditions, for up to 7 days until acceptable flow around the system has been achieved. Additional/ repeat applications of Cleaner F3 2.6G may be necessary if systems are heavily sludged. Drain and flush with cold water until the water is clear and the Cleaner F3 2.6G has been rinsed from the system. Finally, add an appropriate Fernox inhibitor such as Protector F1 2.6G to prevent further corrosion damage and scale deposits.
Colour: Amber
Odour: Faintly aromatic
Form: Liquid
pH (conc): 6.6
pH (in-use) 6.5 – 7.7
SG: 1.116 @ 20°C
Fernox Cleaner F3 2.6G is supplied in 2.6 gallon containers. Fernox Cleaner F3 2.6G is classified as non-hazardous, but as with all chemicals: Keep out of reach of children. Do not mix with other chemicals. In case of contact with eyes or skin, rinse immediately with plenty of water.
© Fernox 2024. All rights reserved
